I'm using OS X El Capitan (10.11) on my MacBook Pro (Retina, 15-inch, Early 2013) and I'm trying to use System Preferences -> Sharing -> Internet Sharing feature and something isn't working. I made sure that Share your connection from. Is set to Wi-Fi as that's my source of internet, and To computers using. Is set to Thunderbolt Ethernet as that's where my Raspberry Pi is plugged in via crossover ethernet cable. I'm not seeing any IP address assigned via Network Utility on Thunderbolt Ethernet (not 100% sure if it should, but I'd assume it should). Apple Network Sharing is and different network channels. I've lost a lot of time on this. Enough so that I'd suggest getting a simple good quality router and setting it up to pick up the wifi ethernet and redistribute it via ethernet. Make sure to set the access point router to act as a bridge (i.e. It would continue to obtain DHCP addresses from the central router). That way you can share to other devices on the master network. You may find you get faster and more reliable internet on your MacBook Pro as well as the aluminum hulls are not particularly reception friendly, especially in comparison with a router with proper antennas which can be positioned as you like. Navigate to the Flashing the BeagleBone Black page, and follow the instructions on how to flash the newly copied image onto the on-board flash memory of the BeagleBone Black. Using the command line Another alternative is to flash the microSD card entirely from the command line. Hope this helps some of you out. Subscribe for Daily Uploads ➕ ✉️ Email: [email protected] ? Website: In this tutorial I explain how to download FL Studio 12 reg key release on Mac OSX. Fl studio mac crack 12. I also explain how to install FL Studio 12 reg key. If you're looking for more tutorials or want to learn how to use different DAWS, please subscribe to our channel! I'm doing something similar but using powerline adapters (more reliable than wifi) to bring the internet to the access point router. Updating BBB to the Latest Image NOTE: This was done on Mac OSX 10.9 with tcsh Download the latest Debian image Or refer to this page for more upto date info NOTE: 'console' version contains minimal system without the FAT partition which contains drivers, etc. 'lxde' version contains everything including the desktop GUI, but the image is huge. Or use images from ErleRobotics which has everything pre-installed and configured. Find out you SD card device's name df -h Unmount the disk partition (but not the disk itself) The partition was /dev/disk7s1 on my system. Change it to your SD card device's name. ![]() Diskutil unmount /dev/disk7s1 Write the image to the SD Card by decompressing it with xzcat|gzcat|zcat and piping the decompressed data to dd. NOTE: Both flasher and SD bootable images available on beagleboard.org contain multiple partitions, so you need to write over the whole disk (/dev/disk7 in my case), NOT just the single partition that you found above (/dev/disk7s1 in my case). This is because the loader on Beaglebone must be able to find uEnv.txt file on a FAT partition which is the first partition (the Linux OS sits on a separate ext4 partition). So in this example, if you've found your SD card disk was mounted at /dev/disk7s1, specify /dev/disk7 as the of target (as of=/dev/disk7 option to the dd command) Ubuntu snappy core image from Erle Robotics.
0 Комментарии
Оставить ответ. |
АвторНапишите что-нибудь о себе. Не надо ничего особенного, просто общие данные. Архивы
Март 2019
Категории |